| Problem: |
Possible Causes/Resolution: |
|
|
| File output unavailable. |
VS3D/VScad3 is not licensed.
See the Installation Guide. |
Sculpture surface looks flat,
but it isn't. |
View was zoomed to a flat part of sculpture.
Display mode "Z Height Shade Range" too large or small.
The visibility of sculpted layers is turned off. |
| Hammering causes no change in sculpture surface. |
No hammer tip defined.
Hammer blow is not within current region.
Hammer blow Z height set to zero and mode set to "+--".
Surface heights on current layer are equal to the hammer blow Z height.
|
| Applying a Region causes no change in sculpture surface. |
No region defined.
Region is hidden.
Region Z height is zero and mode is "+--".
Surface heights on current layer are equal to the region Z height.
|
| Starting a new machining protocol makes surface look flat. |
The existing material heights (before cutting) are correctly shown.
Applying cutting tool paths will reveal the sculpted surface. |
|
|
|
|
